Status:
Not Connected
, No errors

,No msg
Status:
No msg
Mill size
(mm diam):
 Milling speed
(mm/min):
 Movement speed
(mm/min):
 Cutting depth
(mm):
 Position (x,y,z):
(0,0,0)
 Target (x,y,z):
(0,0,0)
X1: Y1: Z1: Milling:
X2: Y2: Z2: Milling:
X3: Y3: Z3: Milling:
X4: Y4: Z4: Milling:
X1: Y1: Z1: Milling:
X2: Y2: Z2: Milling:
X3: Y3: Z3: Milling:
X4: Y4: Z4: Milling:
Name: Load to

Note:Turn and Circle do NOT use Mill size. It is a relative movement only! Hole uses Mill Size

Radius: Start angle: Stop angle: Delta Z:
Radius: Start angle: Delta Z:
Place mill in center! Radius Delta Z:

Note:Slot and Hole uses Mill size. Position in center or where mill should go down

X-size: Y-size: Delta Z: Current Position:
X-size: Y-size: Delta Z: Current Position:
Delta X: Delta Y: Delta Z: Delta X to Center: Delta Y to Center:
Delta X: Delta Y: Delta Z: Delta X to Center: Delta Y to Center:
Debug:
No msg

Mill pos:
No msg

Mill faults:
No msg